Remington bore squeeg-e

just saw an ad for this. just wonder how it would work on a muzzleloader

http://www.squeeg-e.com/#benefits

I ordered the snake, and two tips.
the 50cal/410 (does not sound right to me always cleaned my 45cal with 410 tips) and the 20ga/28ga (thought 50cal muzzleloaders where closer to that)

all the components are in,

the 20ga/28ga tip is as big as the outside of the barrel.
the 50cal/410 slips right in with little contact on my white.
packing states made in the USA

I think i have a gun up for some detail cleaning. see how it works

It sure looks like a great concept.

have not had the chance to test them yet. should monday if it does not rain.

it is a great idea, pulling a piece of rubber down the bore to get all the crud you broke up with a brush, but there is one major flaw. the 50cal/410 sqeeg-e is too small for even cva bores. on my cva wolf, it touched the lands fine, it did not even make contact with the grooves. on my white muzzleloader with a .504 bore, I think it only hit one side of the bore and did not make full contact then. I do not know why remington just did not do just a 50cal muzzleloader. i did do a measurement of it, but I thought I squeezed too much when I did.

I don't own a TC inline or a Traditions inline so I don't know if the Remington squeeg-e will be any better in them.

Idea: great
in practice: fair since you can't make full contact with the barrel to use it how it is should be.

So are saying it would work good on a smooth bore shotgun?

can give it a shot. I have the 20/28 ga version used in the plunger opening of my white, did a good job, would still run a patch or two. I was mainly testing it on muzzleloaders. I picked these up on amazon, think the complete cleaning kits are like $60