finally broke down and start gathering parts for my tc renegade build.

I have an new single stage trigger and a used lock coming off ebay. setting up a small parts order.

the only problem I have is that I can't find a trigger guard. I have a bid on one on ebay, but there is 5days left. you know how that stuff goes.

jan 31
started out the night casting up some 9mm and 40s&w bullets.
pictured two night worth of casting. 88 keepers tonight of 9mm bullets. did not count what was in the bag before that.


then the rest of the night was 2 hours of hand sanding the stock to remove most of the old finish. started with 100grit, when to 150grit then to 220 grit. almost think I should just put 10 coats of polyurethane on it and call it done. lol


good start, I am not going to do anything to the channel until I fit the barrel to it.

does anyone know what size screws I need to mount the tang, trigger guard and other small parts?

little water to show the grain that I found. not alot there from what I can see.


feb 2
the mock up of my 45cal renegade